Description
T-Cell refill adapter for butane!
This adapter is used to refill T-Cell bottles after they have been modified.
To modify them you must make sure the bottle is completely empty and use a paper clip to make sure by poking the brass valve.
Gently take a pair of Needle Nose Pliers and grab the brass piece below the gasket.
Pull straight out until the valve pops out.
Use a drywall screw and screw it into the top of the bottle. Then take pliers and pull on the screw until the check valve pops out. The check valve looks like a little cylinder and might have some blue on it.
Insert brass valve back into Butane Cartridge. (Butane Adaptor is now ready for use!)
Finally, place the adapter on the butane bottle
Fill with Universal Gas Butane Lighter Fluid by inserting the tip on the other side of the adaptor. ***Note: blue adaptor shown in pictures is not included. These plastic tip adaptors are typically found on the lid of universal butane cans***
Lightly apply pressure, while steadily holding the adaptor in place to make a good seal for refilling the cartridge. (too much pressure will cause in leaking of butane gas)
***Disclaimer: Use these adaptors at your own risk, I am not responsible for any injuries that may happen when using this device. (personally I have never had any issues using this adaptor). Do this in a well ventilated area because they may leak a little bit. This is a 3D printed part. Tools and accessories not included***
-Color may vary –
If you have any questions please do not hesitate to reach out. Thank you for your support!
Reviews
There are no reviews yet.